Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER(for 4WD and Pre-Runner) › from 2012.10
RM1840EF _53 Suspension _009620 FRONT SUSPENSION _0052578 FRONT SHOCK ABSORBER(for 4WD and Pre-Runner) A

FRONT SUSPENSION  FRONT SHOCK ABSORBER(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH

F049984

a.

Remove the nut and disconnect the stabilizer link from the steering knuckle.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 3.DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 6.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING

a.
F049985

for 4WD, for Pre-Runner (except TMT and TASA Made):

i.

Remove the nut and bolt.

HINT:

While fixing the nut in place, loosen and remove the bolt.




b.
C273330

for Pre-Runner (TMT and TASA Made):

i.

Remove the nut and bolt.

HINT:

While fixing the nut in place, loosen and remove the bolt.




c.
F049986

Remove the 3 nuts and shock absorber with coil spring.


Hide 7.REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

a.
F049987
2.958,1.573 2.823,1.573 false 2.823,1.573 2.635,1.885 false 3,1.479 3.323,1.677 0.323,0.198 10 false SST

Secure SST in a vise.

SST
09727-30021  (09727-00010, 09727-00031)
09727-00060  


b.
C275706C13
0.208,0.135 0.521,0.292 0.313,0.156 10 false *a 0.271,2.542 0.583,2.698 0.313,0.156 10 false *b
*a Correct
*b Incorrect


Attach the arm of SST to the diameter of the coil spring.

CAUTION:
·

Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.

·

Make sure that the claws of the hooks are securely attached.




c.

Using SST, compress the coil spring.

CAUTION:
·

If the coil spring bends during the compression, immediately stop the compression and reinstall SST.

·

Do not compress the spring until the coil springs contact each other.

·

Do not use an impact wrench.




d.
F049988

Hold the shock absorber rod and remove the nut.

CAUTION:

Do not remove the front support to front shock absorber nut when the coil spring is not free.



Hide 8.REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER

a.

Remove the cushion retainer from the shock absorber.


Hide 9.REMOVE FRONT SHOCK ABSORBER CUSHION

a.

Remove the cushion from the shock absorber.


Hide 10.REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY

a.

Remove the suspension support from the coil spring.


b.

Remove the cushion retainer from the shock absorber.


Hide 11.REMOVE FRONT COIL SPRING LH

a.

Remove the coil spring from the shock absorber.