Home › Suspension › FRONT SUSPENSION › FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner)
RM1840EF _53 Suspension _009620 FRONT SUSPENSION _0052580 FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner) G

FRONT SUSPENSION  FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT UPPER SUSPENSION ARM ASSEMBLY LH

F050003

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.98 to 4.5 N*m (10 to 46 kgf*cm, 9 to 40 in.*lbf) or less



c.

Check for any cracks and grease leaks on the ball joint dust cover.