Home › Suspension › FRONT SUSPENSION › FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner)
RM1840EF _53 Suspension _009620 FRONT SUSPENSION _0052580 FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner) A

FRONT SUSPENSION  FRONT UPPER SUSPENSION ARM(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE FRONT SPEED SENSOR LH (w/ ABS)

a.
F049997

Remove the 2 bolts and disconnect the speed sensor wire.


Hide 3.DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH

a.
F049984

Remove the nut and disconnect the stabilizer link from the steering knuckle.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 4.REMOVE FRONT UPPER SUSPENSION ARM ASSEMBLY LH

F102350
1.969,1.344 2.354,0.885 2.354,0.885 2.677,0.885 true 2.719,0.781 3.177,0.979 0.458,0.198 10 false SST

a.

Support the lower arm with a jack.


b.

Remove the clip and nut.


c.

Using SST, disconnect the upper ball joint from the steering knuckle.

SST
09628-62011  


d.
F050000

Remove the nut, 2 retainers and bolt.


e.

Remove the upper arm.


Hide 5.REMOVE FRONT UPPER ARM BUSH

a.
F050001

Using a hammer and chisel, strike and bend the entire flange of the bush as shown in the illustration.


b.
F050002
2.396,0.948 2.5,0.677 2.5,0.677 2.583,0.677 false 1.51,1.542 1.313,1.385 true 1.104,1.615 1.51,1.542 false 1.542,1.448 1.979,1.646 0.438,0.198 10 false SST 2.615,0.573 2.854,0.771 0.24,0.198 10 false *1
*1 Bush


Using SST and a press, press out the upper arm bush.

SST
09613-26010  
09710-22021  (09710-01041)
09950-00020  


Hide 6.REMOVE UPPER BALL JOINT DUST COVER

a.

Remove the dust cover set ring and dust cover from the upper arm.

NOTICE:
·

Do not damage the ball joint dust cover.

·

If the ball joint dust cover is damaged, replace it.




Hide 7.REMOVE FRONT UPPER BALL JOINT

a.
C237895

Using a snap ring expander, remove the snap ring.


b.
C237642
0.583,0.635 1.021,0.208 false 1.021,0.208 1.25,0.208 false 0.927,2.469 0.698,2.469 0.698,2.469 0.479,1.906 false 1,2.375 1.385,2.563 0.385,0.188 10 false SST 1.302,0.135 1.688,0.323 0.385,0.188 10 false SST

Using SST and a press, press out the upper ball joint.

SST
09612-30012  
09388-40010