Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR(for 4WD and Pre-Runner)
RM1840EF _53 Suspension _009620 FRONT SUSPENSION _0052581 FRONT STABILIZER BAR(for 4WD and Pre-Runner) A

FRONT SUSPENSION  FRONT STABILIZER BAR(for 4WD and Pre-Runner)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT STABILIZER BAR

a.

Install the front stabilizer bar to the vehicle body.


Hide 2.INSTALL FRONT NO. 1 STABILIZER BAR BUSH

a.
C118729
1.083,1.188 0.604,1.188 false 0.406,1.104 0.635,1.281 0.229,0.177 10 *1 2.917,1.573 3.104,1.76 0.188,0.188 10 *b 2.688,0.052 2.948,0.24 0.26,0.188 10 *a
*1 Bush Stopper
*a Outer Side
*b Vehicle Front


Install the 2 bushes.

HINT:
·

Install each bush to the outer side of the bush stopper on the stabilizer bar.

·

Install each bush with the slit of the bush facing the front of the vehicle.




Hide 3.INSTALL FRONT STABILIZER BRACKET

a.
C118728

Install the 2 brackets with the 4 bolts.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)

HINT:

Make sure the bracket's arrows face the front of the vehicle.



Hide 4.INSTALL FRONT STABILIZER LINK ASSEMBLY LH

a.
C118727

Install the front stabilizer link assembly LH with the 2 nuts.

Torque:
70 N*m (714 kgf*cm, 52 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 5.INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 6.INSTALL FRONT WHEEL

Torque:
105 N*m (1071 kgf*cm, 77 ft.*lbf)