Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR(for 2WD) › from 2012.10
RM1840EF _53 Suspension _009620 FRONT SUSPENSION _0052585 FRONT STABILIZER BAR(for 2WD) A

FRONT SUSPENSION  FRONT STABILIZER BAR(for 2WD)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT STABILIZER BAR

a.

Install the front stabilizer bar to the vehicle body.


Hide 2.INSTALL FRONT NO. 1 STABILIZER BAR BUSH

a.
C180046
0.406,1.385 1.375,1.385 true 1.375,1.385 1.448,1.313 true 0.167,1.292 0.406,1.51 0.24,0.219 10 false *1 2.771,0.031 3.031,0.271 0.26,0.24 10 false *a 2.979,1.698 3.188,1.885 0.208,0.188 10 false *b
*1 Bush Stopper
*a Outer Side
*b Vehicle Front


Install the 2 bushes.

HINT:
·

Install each bush to the outer side of the bush stopper on the stabilizer bar.


·

Install each bush with the slit of the bush facing the front of the vehicle.




Hide 3.INSTALL FRONT STABILIZER BRACKET

a.

Install the 2 brackets with the 4 bolts.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)

HINT:

Make sure the brackets' arrows face the front of the vehicle.



Hide 4.INSTALL FRONT STABILIZER LINK ASSEMBLY LH

a.

Install the 2 retainers, 2 cushions and stabilizer link.


b.

Install the front stabilizer link assembly LH with a new nut (upper side) and the nut (lower side).

Torque:
for upper side : 27 N*m (316 kgf*cm, 23 ft.*lbf)
for lower side : 78 N*m (795 kgf*cm, 58 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 5.INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 6.INSTALL FRONT WHEEL

Torque:
152 N*m (1550 kgf*cm, 112 ft.*lbf)