Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER(for 4WD and Pre-Runner)
RM1840EF _53 Suspension _009621 REAR SUSPENSION _0052587 REAR SHOCK ABSORBER(for 4WD and Pre-Runner) A

REAR SUSPENSION  REAR SHOCK ABSORBER(for 4WD and Pre-Runner)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

C113168

a.

Install the 2 washers to the axle housing.


b.

Install 4 new bushes to the absorber.


c.

Install the absorber (with the 4 bushes) to the U bolt seat and frame.


d.

Install the 2 washers.


e.

Temporarily install the 2 bolts.


Hide 2.INSTALL REAR WHEEL

a.

Install the wheel.

Torque:
105 N*m (1070 kgf*cm, 77 ft.*lbf)


Hide 3.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Press down on the vehicle several times to stabilize the suspension.


Hide 4.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the 2 bolts.

Torque:
105 N*m (1070 kgf*cm, 77 ft.*lbf)