Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER(for 4WD and Pre-Runner)
RM1840EF _53 Suspension _009621 REAR SUSPENSION _0052587 REAR SHOCK ABSORBER(for 4WD and Pre-Runner) A

REAR SUSPENSION  REAR SHOCK ABSORBER(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH

C113168

a.

Support the rear axle housing.

i.

Jack up and support the vehicle's frame on stands.


ii.

Lower the axle housing until the leaf spring tension is free, and maintain this position.



b.

Remove the 2 bolts and 2 washers.


c.

Disconnect the absorber (with the 4 bushes) from the U bolt seat and frame.


d.

Remove the 4 bushes from the absorber.


e.

Remove the 2 washers.