Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
1.REMOVE REAR WHEEL
2.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the bolt and disconnect the cable from the spring.
3.REMOVE REAR SHOCK ABSORBER ASSEMBLY
4.REMOVE REAR SPRING BUMPER SUB-ASSEMBLY
Remove the 2 bolts and spring bumper.
5.REMOVE REAR SPRING U BOLT
Remove the 4 nuts, 4 washers, 2 U bolts and U bolt seat.
6.REMOVE REAR LEAF SPRING BRACKET PIN OR PIN BOLT
Remove the set bolt.
Remove the nut, washer and bracket pin.
7.REMOVE SPRING SHACKLE INNER PLATE
Remove the 2 nuts, 2 washers and inner plate.
8.REMOVE NO. 2 REAR SPRING SHACKLE SUB-ASSEMBLY
Using a screwdriver, remove the spring shackle.
9.REMOVE REAR LEAF SPRING ASSEMBLY LH
Remove the spring from the vehicle body.