1.REMOVE REAR SPRING PIN BUSH
Using a screwdriver, remove the 2 bushes from the bracket pin or spring.
2.REMOVE REAR SPRING SHACKLE LOWER BUSH
Using a screwdriver, remove the 2 bushes from the spring shackle or spring.
3.REMOVE REAR SPRING SHACKLE UPPER BUSH
Using a screwdriver, remove the 2 bushes from the spring shackle or vehicle frame.
4.DISASSEMBLE REAR SPRING ASSEMBLY
Secure the rear leaf spring assembly in a vise between aluminum plates.
Using a brass bar and hammer, pry open the 4 spring clips of the rear No. 3 leaf spring.
Do not damage the leaf spring.
Secure the spring with a vise as shown in the illustration.
Remove the nut and center bolt.
Remove the rear No. 3 spring spacer.
Remove the rear No. 1 spring spacer.
5.REMOVE REAR SPRING SILENCER
Remove the 4 rear spring silencers from the leaf spring.
6.REMOVE REAR SPRING LEAF BUSH
Fix the spring in place with a vise.
Using a metal saw, cut both ends of the bush.
Using SST and a press, press out the 2 bushes.
Using a chisel and hammer, tap out the 2 outer tubes.