Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(w/ VSC) › 2011.10–2012.01
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052592 BRAKE ACTUATOR(w/ VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(w/ VSC)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 4.REMOVE BRAKE ACTUATOR ASSEMBLY

a.
C247704
2.115,1.115 2.281,0.771 2.281,0.771 2.458,0.771 false 1.906,1.073 1.906,0.375 1.906,0.375 2.167,0.375 false 1.688,1.021 1.688,0.219 1.688,0.219 1.583,0.219 false 1.375,1 1.01,0.385 1.01,0.385 0.781,0.385 false 1.5,1.396 1.5,3.073 1.5,3.073 2.24,3.073 false 1.771,1.458 1.771,3.063 false 2.24,0.281 2.563,0.479 0.323,0.198 10 *1 2.5,0.688 2.792,0.833 0.292,0.146 10 *2 0.594,0.302 0.865,0.479 0.271,0.177 10 *3 1.396,0.146 1.667,0.313 0.271,0.167 10 *4 2.26,2.979 2.594,3.208 0.333,0.229 10 *5

Place tags or marks to identify the installation locations of each brake line.

HINT:
·

*1: to front wheel cylinder RH

·

*2: to front wheel cylinder LH

·

*3: to rear wheel cylinder RH

·

*4: to rear wheel cylinder LH

·

*5: from master cylinder




b.
C247705

Pull the lock lever upward and disconnect the connector.

NOTICE:

Be careful not to allow brake fluid to enter the removed connector.



c.

Using a union nut wrench, disconnect the 6 brake lines from the brake actuator.


d.

Remove the 3 bolts, nut and actuator with bracket.

NOTICE:
C194679

Be careful not to damage the brake tubes.



Hide 5.REMOVE NO. 3 BRAKE ACTUATOR BRACKET

a.
C194683

Remove the bolt and No. 3 brake actuator bracket.