Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(w/ ABS) › 2011.10–2012.01
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052593 BRAKE ACTUATOR(w/ ABS) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(w/ ABS)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 4.REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET

a.
C121394
1.583,1.094 2.646,1.521 2.646,1.521 2.646,2.438 false 1.208,0.854 1.208,0.167 1.208,0.167 2.698,0.167 false 1.365,0.792 1.365,0.531 1.365,0.531 2.021,0.531 false 1.104,1.781 0.448,1.781 false 0.823,1.438 0.438,1.438 0.438,1.438 0.438,2.74 false 2.719,0.083 3.031,0.271 0.313,0.188 10 *2 2.031,0.458 2.323,0.646 0.292,0.188 10 *1 2.563,2.438 2.875,2.729 0.313,0.292 10 *3 0.354,2.75 0.656,2.99 0.302,0.24 10 *4

Place tags or marks to identify the installation locations of each brake line.

HINT:
·

*1: to front wheel cylinder RH

·

*2: to front wheel cylinder LH

·

*3: to rear wheel cylinder

·

*4: from master cylinder




b.

Release the latch of the actuator connector and disconnect the connector.


c.

Detach the clip from the brake actuator bracket.


d.
C121395

Using a union nut wrench, disconnect the 5 brake lines from the brake actuator.


e.
C121396

Remove the 3 bolts and brake actuator with bracket.

NOTICE:

Be careful not to damage the brake tubes.