Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR(for 4WD and Pre-Runner) › from 2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052594 FRONT SPEED SENSOR(for 4WD and Pre-Runner) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR(for 4WD and Pre-Runner)  INSPECTION  


PROCEDURE

Hide 1.CHECK FRONT SPEED SENSOR

a.

Check the speed sensor.

i.

Under any of the following conditions, replace the sensor with a new one.

·

The surface of the sensor is cracked, dented or chipped.

·

The connector is scratched, cracked or damaged.

·

The sensor has been dropped.



ii.
C189989
0.115,0.115 0.375,0.333 0.26,0.219 10 *a
*a Component without harness connected
(Front Speed Sensor)


w/ ABS:

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Specified Condition
1 - 2 0.65 to 1.8 kΩ
1 - Body ground 10 kΩ or higher
2 - Body ground 10 kΩ or higher


If the result is not as specified, replace the speed sensor.

HINT:

Check the speed sensor signal after replacing the speed sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>FRONT SPEED SENSOR(for 4WD and Pre-Runner)>INSTALLATION).