The procedure listed below is for the LH side.
Other than areas where instructions are provided, use the same procedure for the LH and RH sides.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE FRONT WHEEL
4.REMOVE FRONT SPEED SENSOR LH
Disconnect the connector.
| *A | for LH | *B | for RH |
Detach the 2 clamps and the connector.
Detach the 2 clamps.
Detach the clamp.
Remove the 2 bolts and 2 harness clamps.
Detach the 2 clamps.
| *A | w/ VSC | *B | w/o VSC |
Remove the bolt and harness clamp.
Remove the bolt and speed sensor.
Keep the sensor tip and sensor installation hole free from foreign matter.
5.REMOVE SKID CONTROL SENSOR CLAMP
Remove the bolt and skid control sensor clamp from the knuckle.
| *A | for LH | *B | for RH |