Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR › 2012.04–2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052595 REAR SPEED SENSOR G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSPECTION  


PROCEDURE

Hide 1.CHECK REAR SPEED SENSOR

a.

Check the speed sensor.

i.

Under any of the following conditions, replace the sensor with a new one.

·

The surface of the sensor is cracked, dented or chipped.

·

The connector is scratched, cracked or damaged.

·

The sensor has been dropped.



ii.
C225648
0.259,0.952 0.433,1.139 0.175,0.186 10 *A 0.259,2.594 0.44,2.752 0.182,0.159 10 *B 0.056,0.019 0.261,0.203 0.205,0.184 10 *a
*A for LH
*B for RH
*a Component without harness connected
(Rear Speed Sensor)


w/ ABS:

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Specified Condition
1 - 2 0.65 to 2.0 kΩ
1 - Body ground 10 kΩ or higher
2 - Body ground 10 kΩ or higher


If the result is not as specified, replace the rear speed sensor.

HINT:

Check the speed sensor signal after replacing the speed sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>REAR SPEED SENSOR>INSTALLATION).