1.CHECK REAR SPEED SENSOR
Check the speed sensor.
Under any of the following conditions, replace the sensor with a new one.
The surface of the sensor is cracked, dented or chipped.
The connector is scratched, cracked or damaged.
The sensor has been dropped.
| *A | for LH |
| *B | for RH |
| *a | Component without harness connected
(Rear Speed Sensor) |
w/ ABS:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
|---|---|
| 1 - 2 | 0.65 to 2.0 kΩ |
| 1 - Body ground | 10 kΩ or higher |
| 2 - Body ground | 10 kΩ or higher |
If the result is not as specified, replace the rear speed sensor.
Check the speed sensor signal after replacing the speed sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>REAR SPEED SENSOR>INSTALLATION).