Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DECELERATION SENSOR(w/o VSC)
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052596 DECELERATION SENSOR(w/o VSC) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DECELERATION SENSOR(w/o VSC)  INSPECTION  


PROCEDURE

Hide 1.INSPECT DECELERATION SENSOR

a.

Connect 3 dry cell batteries of 1.5 V in series (approximately 4.5 V in total).


b.

Connect the batteries' positive (+) lead to terminal 3 (VGS) and the negative (-) lead to terminal 2 (GGND).

NOTICE:

Do not apply 6 V or more to terminals 3 (VGS) and 2 (GGND).



c.

Connect the voltmeter's positive (+)lead to the negative (-) lead of the batteries, and the negative (-) lead to terminal 1 (GL1).


d.
C108887
2.125,0.938 1.354,0.667 true 2.344,0.938 2.375,0.406 2.375,0.406 2.208,0.406 true 2.531,0.958 2.698,0.208 true 1.74,0.281 1.906,0.479 0.167,0.198 10 false 2 2.74,0.083 3.177,0.25 0.438,0.167 10 false 1 1.198,0.563 1.385,0.74 0.188,0.177 10 false 3 2.448,2.406 2.688,2.656 0.24,0.25 10 false *a 2.24,3.313 2.49,3.531 0.25,0.219 10 false *b 1.167,4.167 1.448,4.438 0.281,0.271 10 false *c 2.75,0.24 3.25,0.417 0.5,0.177 10 false (GL1) 1.771,0.427 2.688,0.625 0.917,0.198 10 false (GGND) 1.146,0.719 1.917,0.917 0.771,0.198 10 false (VGS)
*a Front
*b Forward
*c Rearward


Check the output voltage of terminal 1 (GL1) when the sensor is tilted forward and rearward.

Standard Voltage:
Tester Connection Condition Specified Condition
1 (GL1) - Battery negative (-) lead Sensor is horizontal Approx. 2.25 V
1 (GL1) - Battery negative (-) lead Sensor is tilted forward Approx. 0.45 to 2.25 V
1 (GL1) - Battery negative (-) lead Sensor is tilted rearward Approx. 2.25 to 4.05 V


If the result is not as specified, replace the deceleration sensor.

HINT:
·

If the voltage drops, the sensor should be replaced with a new one.

·

When replacing the sensor, it should not be placed upside down.




Hide 2.CHECK DECELERATION SENSOR

a.

Check the deceleration sensor.

Under any of the following conditions, replace the sensor with a new one.

·

The surface of the sensor is cracked, dented or chipped.

·

The connector is scratched, cracked or damaged.

·

The sensor has been dropped.