Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DECELERATION SENSOR(w/o VSC) › from 2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052596 DECELERATION SENSOR(w/o VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DECELERATION SENSOR(w/o VSC)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT SEAT ASSEMBLY RH

Hide 4.REMOVE FLOOR CARPET COVER

a.
C189946

Detach the 4 claws and remove the floor carpet cover.


Hide 5.REMOVE SENSOR BRACKET

a.

Remove the 2 bolts and sensor bracket.


Hide 6.REMOVE DECELERATION SENSOR

a.
C280635

Disconnect the deceleration sensor connector.


b.

Remove the deceleration sensor.