Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR(w/ VSC) › 2012.04–2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052598 STEERING ANGLE SENSOR(w/ VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

(See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION)

NOTICE:
·

Do not replace the spiral cable with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with the battery connected and the ignition switch ON.

·

Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

·

Do not remove the steering angle sensor from the spiral cable.



Hide 5.INSTALL STEERING WHEEL ASSEMBLY

Hide 6.INSTALL STEERING PAD

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).