Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052600 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the intelligent tester to the vehicle and reading various data output from the vehicle's skid control ECU (brake actuator assembly).

The skid control ECU records DTCs when the ECU detects a malfunction in the ECU itself or in its circuits. To check the DTCs, connect the intelligent tester to the DLC3 on the vehicle.

The intelligent tester enables you to clear the DTCs, activate the various actuators, and check the freeze frame data and Data List.

a.

Check the battery voltage.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge the battery before proceeding to the diagnosis.




DIAGNOSIS


a.

If the skid control ECU (brake actuator assembly) detects a malfunction, the ABS warning light will come on to warn the driver.

The DTCs are simultaneously stored in memory.

The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning light, or by connecting the intelligent tester (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).

This system has a Test Mode (signal check) function (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).