Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2011.10–2012.10
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052600 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


a.

Whenever a DTC is stored, the skid control ECU (brake actuator assembly) stores the current vehicle state as freeze frame data.


b.

The skid control ECU (brake actuator assembly) stores the number of times (maximum: 31) the ignition switch has been turned from off to ON since the last time the ABS was activated.

HINT:
·

If the vehicle is stopped or at a low speed (7 km/ h (4 mph) or less), or if a DTC is stored, the skid control ECU (brake actuator assembly) stops counting the number of times the ignition switch has been turned from off to ON.

·

Freeze frame data at the time the ABS operates: The skid control ECU (brake actuator assembly) stores and updates data whenever the ABS operates. When the ECU stores data at the time a DTC is stored, the data stored during ABS operation is cleared.

·

Freeze frame data at the time a DTC is stored: When the skid control ECU (brake actuator assembly) stores data at the time a DTC is stored, no updates are performed until the data is cleared.





CHECK FREEZE FRAME DATA


a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / DTC.


e.

According to the display on the intelligent tester, select the trouble code data display with freeze frame data.

Chassis > ABS/VSC/TRC
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Stop Light SW Stop light switch signal ON or OFF ON: Brake pedal depressed
OFF: Brake pedal not depressed
-
Operated System Operated system status no Sys, ABS, VSC(TRC), BA, HAB, FAIL SAFE, PBA or PB - ABS: ABS operating
Number of IG ON Number of times ignition switch turned to ON after storing freeze frame data 0 to 31 - -
Vehicle Speed Maximum wheel speed sensor value Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Actual vehicle speed The speed which was indicated on the speedometer.
Back And Forth G Forward and rearward gravitational force (G) Min.: -1.86 G
Max.: 1.85G
- Changes in proportion to acceleration during acceleration/ deceleration.


CLEAR FREEZE FRAME DATA


NOTICE:

Clearing the DTC also clears the freeze frame data.