1.CHECK AND ADJUST BRAKE PEDAL HEIGHT
| *1 | Stop Light Switch |
| *2 | Push Rod |
| *3 | Lock Nut |
| *a | Pedal Height |
Check the pedal height.
| Model | Specified Condition |
|---|---|
| for Manual Transmission | 152.9 to 162.9 mm (6.020 to 6.413 in.) |
| for Automatic Transmission | 154.1 to 164.1 mm (6.067 to 6.461 in.) |
Adjust the pedal height.
Disconnect the connector from the stop light switch.
Remove the switch.
Loosen the push rod clevis lock nut.
Adjust the pedal height by turning the push rod.
Tighten the lock nut.
| *1 | Brake Pedal |
| *2 | Adjuster |
| *3 | Stop Light Switch |
Insert the switch into the adjuster until it slightly touches the pedal.
Do not depress the pedal.
| *1 | Shaft |
| *2 | Stop Light Switch |
Turn the switch a quarter turn clockwise.
or less
Do not depress the pedal.
Connect the connector to the switch.
Check the switch clearance.
1.5 to 2.5 mm (0.0591 to 0.0984 in.)
2.CHECK BRAKE PEDAL FREE PLAY
| *a | Pedal Free Play |
Stop the engine. Depress the pedal several times until there is no vacuum in the booster. Then release the pedal.
Depress the pedal until resistance is felt.
Check the pedal free play by measuring the distance between the position in the previous step and the released position of the pedal.
1.0 to 6.0 mm (0.0394 to 0.236 in.)
If the free play is not as specified, check the switch clearance in the next step.
If the free play is as specified, proceed to the "Check Brake Pedal Reserve Distance" procedure.
Check the switch clearance.
1.5 to 2.5 mm (0.0591 to 0.0984 in.)
If the clearance is not as specified, adjust the clearance and recheck the pedal free play.
If the clearance is as specified, troubleshoot the brake system and proceed to the "Check Brake Pedal Reserve Distance" procedure.
3.CHECK BRAKE PEDAL RESERVE DISTANCE
| *1 | Dash Panel |
| *a | Pedal Reserve Distance |
Release the parking brake lever. Start the engine.
Depress the pedal and check the pedal reserve distance.
Depress the pedal with a force of 490 N (50 kgf, 110 lbf).
Measure the distance between the pedal and dash panel shown in the illustration.
| Item | Specified Condition |
|---|---|
| for 15 inch Front Disc Brake | 85.0 mm (3.347 in.) |
| for 16 inch Front Disc Brake | 76.0 mm (2.992 in.) |
If the distance is not as specified, troubleshoot the brake system.