Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(w/ VSC)
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052609 BRAKE MASTER CYLINDER(w/ VSC) G

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/ VSC)  INSPECTION  


PROCEDURE

Hide 1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

HINT:

Adjust the booster push rod when the master cylinder is replaced with a new one. Adjustment is not necessary when the master cylinder is reinstalled and the booster is replaced with a new one.


a.
C283544
2.25,2.781 2.583,3.281 2.583,3.281 2.885,3.281 true 1.365,1.854 1.219,2.01 1.219,2.01 0.969,2.01 false 0.948,3.979 0.75,3.771 0.75,3.771 0.531,3.771 false 2.958,3.177 3.271,3.333 0.313,0.156 10 false *a 0.635,1.906 1.094,2.104 0.458,0.198 10 false SST 0.167,3.688 0.625,3.885 0.458,0.198 10 false SST
*a Apply Chalk


Set SST on the master cylinder and lower the rod of SST until it just touches the piston.

SST
09737-00013  

HINT:

SST 09797-00012 can also be used.



b.

Apply chalk to the flat tip of the rod of SST. Turn SST upside down and measure the clearance between the brake booster push rod and SST.

Standard clearance:

0 mm (0 in.)


If there is clearance between the main body of SST and the shell of the brake booster, the push rod is protruding too far. If the chalk does not stick to the tip of the brake booster push rod, the push rod protrusion is insufficient.


c.
F040006
0.552,0.396 0.323,0.76 false 0.156,0.771 0.448,0.969 0.292,0.198 10 false SST

If the clearance is not as specified, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.

SST
09737-00020  

NOTICE:

Check the push rod clearance again after adjustment.