Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.
1.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
for Manual Transmission:
Disconnect the clutch reservoir tube from the brake master cylinder reservoir.
Disconnect the brake fluid level warning switch connector.
Using a union nut wrench, disconnect the 4 brake lines from the brake master cylinder and brake tube way.
Remove the 2 nuts and brake tube way.
Pull out the brake master cylinder from the brake booster.
Remove the O-ring from the brake master cylinder.