Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1KD-FTV, 2KD-FTV)
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052613 VACUUM PUMP(for 1KD-FTV, 2KD-FTV) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1KD-FTV, 2KD-FTV)  REMOVAL  


PROCEDURE

Hide 1.REMOVE NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 2.REMOVE NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 3.REMOVE RADIATOR ASSEMBLY

Hide 6.REMOVE VACUUM PUMP ASSEMBLY

a.

Disconnect the 2 vacuum hoses from the pump.


b.
C111342

Remove the 2 nuts and pull out the pump from the engine.


c.

Remove the 2 O-rings.


Hide 7.REMOVE CHECK VALVE SUB-ASSEMBLY

a.
C111343

Mount the pump in a vise

NOTICE:

Place aluminum plates on the vise to prevent damage to the pump.



b.

Remove the union bolt, union and 2 gaskets.


c.
C111344

Remove the check valve and gasket.


Hide 8.REMOVE VACUUM PUMP END COVER

a.
C111345

Remove the 3 bolts.


b.
C111346

Using a 5 mm pin punch and hammer, tap out the 2 straight pins.


c.

Remove the end cover and 2 O-rings.


Hide 9.REMOVE VACUUM PUMP BLADE

a.
C111347

Remove the rotor together with the 5 blades.

NOTICE:

Be careful not to drop the blades.



b.

Remove the 5 blades from the rotor.


Hide 10.REMOVE VACUUM PUMP GEAR

a.
C111348

Mount the gear in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the gear.



b.

Remove the gear lock nut.


c.

Remove the gear and woodruff key.


Hide 11.REMOVE VACUUM PUMP SHAFT

a.
C111349

Using snap ring pliers, remove the snap ring.


b.
C111350

Using a plastic-faced hammer, tap out the shaft.


Hide 12.REMOVE VACUUM PUMP BEARING

a.
C111351

Using a 17 mm socket wrench and press, press out the bearing.