Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1KD-FTV, 2KD-FTV)
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052613 VACUUM PUMP(for 1KD-FTV, 2KD-FTV) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1KD-FTV, 2KD-FTV)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK VACUUM PUMP ASSEMBLY

a.

Disconnect the vacuum hose from the vacuum pump.


b.
C111341
2.583,0.375 2.99,0.375 2.99,0.375 2.99,0.698 false 3,1.854 3,1.917 3,1.917 2.042,1.917 false 2.927,0.792 3.177,1.063 0.25,0.271 10 false *1 1.792,1.833 2.052,2.052 0.26,0.219 10 false *2
*1 Vacuum Gauge
*2 Plug


Connect the hose of a vacuum gauge to the pump.


c.

Insert a plug into the other hose of the gauge.


d.

Start the engine and warm it up for more than 2 minutes.


e.

With the engine idling, check the negative pressure of the pump.

Standard negative pressure:

More than 86.7 kPa (650 mmHg, 26 in.Hg)


HINT:

The vacuum pump assembly is listed as one of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 miles) and replace parts as necessary.



f.

Remove the gauge from the pump.


g.

Connect the hose to the pump with the clip.