1.CHECK LOAD SENSING PROPORTIONING VALVE ASSEMBLY
| *a | Weight |
Set the vehicle to its curb weight.
Place weights (as necessary) on the rear deck until the rear axle load is as shown below.
| Vehicle Type | Specified condition |
|---|---|
| except 1GR-FE | 9807 N (1000 kgf, 2205 lbf) |
| for 1GR-FE | 10297 N (1050 kgf, 2315 lbf) |
Be sure that the vehicle is on a level surface before starting the procedure.
After placing approximately 60 kg (132 lb) more than the set value, remove weights slowly as necessary so that the load is within +/-15 kg (33 lb) of the adjusted value and there is less than a 25 kg (55 lb) difference between the right and left sides.
Install SST and bleed air from the brake system.
Raise the front brake fluid pressure to 10000 kPa (107.6 kgf/cm2, 1450 psi) by depressing the brake pedal, and measure the rear brake fluid pressure.
4450 +/-490 kPa (45.4 +/-5.0 kgf/cm2, 645 +/-71 psi)
The pedal should not be depressed twice or released while raising the front brake fluid pressure.
Read the value of the rear brake fluid pressure after raising and holding the front fluid pressure for 2 seconds.
If necessary, adjust the load sensing proportioning valve.
2.ADJUST LOAD SENSING PROPORTIONING VALVE ASSEMBLY
Adjust the length of the No. 2 load sensing spring shackle.
When the rear brake fluid pressure is below the standard pressure, lengthen length A.
When the rear brake fluid pressure is higher than the standard pressure, shorten length A.
190 mm (7.543 in.)
184 to 196 mm (7.305 to 7.781 in.)
The rear brake fluid pressure changes according to the table below by adjusting length A.
Changes by 120 kPa (1.2 kgf/cm2, 17.6 psi) for every 1 mm (0.0394 in.) change in length A
If the pressure cannot be adjusted by the No. 2 load sensing spring shackle, loosen the nuts and raise or lower the valve body.
When the pressure is below the standard pressure, lower the load sensing valve assembly.
When the pressure is higher than the standard pressure, raise the load sensing valve assembly.
Tighten the nuts.
Adjust the length of the No. 2 load sensing spring shackle again.
If the length cannot be adjusted, check the load sensing valve assembly.
3.CHECK VALVE BODY
Check that the master cylinder rear brake fluid pressure changes according to the rear wheel cylinder pressure.
| Master Cylinder Pressure | Wheel Cylinder Pressure |
|---|---|
| 2940 kPa (29 kgf/cm2, 428 psi) | 1270 +/-200 kPa (13.0 +/-2 kgf/cm2, 185 +/-29 psi) |
| 5880 kPa (59 kgf/cm2, 855 psi) | 1720 +/-340 kPa (17.5 +/-3 kgf/cm2, 250 +/-49 psi) |
If the result is not as specified, replace the load sensing valve assembly.