1.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o ABS)
Disconnect the clutch reservoir tube labeled A from master cylinder.
Disconnect the brake fluid level warning switch connector labeled B.
Using a union nut wrench, disconnect the 6 brake lines labeled C from the master cylinder and 4-way.
Remove the 2 nuts and bracket (with 4-way).
Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.
3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ ABS)
for Manual Transmission:
Disconnect the clutch reservoir tube labeled A from the master cylinder.
Disconnect the brake fluid level warning switch connector labeled B.
Using a union nut wrench, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.
Remove the 2 nuts and bracket (with 3-way).
Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.
4.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
Remove the screw.
Remove the reservoir and 2 grommets from the master cylinder.