Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID(for TSAM Made) › from 2012.04
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052619 BRAKE FLUID(for TSAM Made) A

BRAKE SYSTEM (OTHER)  BRAKE FLUID(for TSAM Made)  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

If any work is performed on the brake system or if air in the brake lines is suspected, bleed the brake system.


NOTICE:
·

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.

·

If brake fluid leaks onto any painted surface, immediately wash it off.

·

Bleed the brake line of the wheel farthest from the master cylinder first.



PROCEDURE

Hide 1.REPLACE BRAKE FLUID

a.

Remove the brake master cylinder reservoir filler cap assembly.


b.

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.

Fluid:

J1704 or FMVSS No. 116 DOT 4



c.

Remove the bleeder plug cap.


d.

Connect a vinyl tube to the bleeder plug.


e.

Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1


f.

When fluid stops coming out, tighten the bleeder plug, and then release the brake pedal.*2


g.

Repeat *1 and *2 until all air in the fluid is completely bled out.


h.

Tighten the bleeder plug completely.

Torque:
for Front Brake : 11 N*m (110 kgf*cm, 8 ft.*lbf)
for Rear Brake : 10 N*m (102 kgf*cm, 7 ft.*lbf)


i.

Install the bleeder plug cap.


j.

Repeat the above procedure for each wheel to bleed the brake line.


k.

Check for brake fluid leaks.


l.

Check the brake fluid level in the reservoir (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for TSAM Made)>ON-VEHICLE INSPECTION).