Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for TSAM Made) › 2012.04–2013.10
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052621 BRAKE MASTER CYLINDER(for TSAM Made) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for TSAM Made)  REMOVAL  


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o ABS)

a.
C281949
2.313,0.292 2.469,0.49 0.156,0.198 10 false A 1.188,0.667 1.344,0.865 0.156,0.198 10 false B 1.792,0.969 1.948,1.167 0.156,0.198 10 false C 2.167,1.302 2.323,1.5 0.156,0.198 10 false C 0.771,1.125 0.927,1.323 0.156,0.198 10 false C 0.698,1.25 0.854,1.448 0.156,0.198 10 false C 1.51,1.438 1.667,1.635 0.156,0.198 10 false C 0.75,1.875 0.906,2.073 0.156,0.198 10 false C

Disconnect the clutch reservoir tube labeled A from master cylinder.


b.

Disconnect the brake fluid level warning switch connector labeled B.


c.

Using a union nut wrench, disconnect the 6 brake lines labeled C from the master cylinder and 4-way.


d.
C122645

Remove the 2 nuts and bracket (with 4-way).


e.

Pull out the master cylinder from the brake booster.


f.

Remove the O-ring from the master cylinder.


Hide 3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ ABS)

C281950
2.281,0.333 2.438,0.531 0.156,0.198 10 false A 2.094,1.302 2.25,1.5 0.156,0.198 10 false C 1.156,0.625 1.313,0.823 0.156,0.198 10 false B 1.74,1.01 1.896,1.208 0.156,0.198 10 true C 1.417,1.438 1.573,1.635 0.156,0.198 10 true C 0.719,1.146 0.875,1.344 0.156,0.198 10 false C 0.635,1.25 0.792,1.448 0.156,0.198 10 false C

a.

for Manual Transmission:

Disconnect the clutch reservoir tube labeled A from the master cylinder.


b.

Disconnect the brake fluid level warning switch connector labeled B.


c.

Using a union nut wrench, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.


d.
C122647

Remove the 2 nuts and bracket (with 3-way).


e.

Pull out the master cylinder from the brake booster.


f.

Remove the O-ring from the master cylinder.


Hide 4.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.

Remove the screw.


b.

Remove the reservoir and 2 grommets from the master cylinder.