Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for TDV Made) › from 2012.04
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052622 BRAKE MASTER CYLINDER(for TDV Made) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for TDV Made)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o ABS)

C247716

a.

for Manual Transmission:

Disconnect the clutch reservoir tube from the master cylinder.


b.

Disconnect the brake fluid warning switch connector.


c.

Using a union nut wrench, disconnect the 6 brake lines from the master cylinder and 4-way.


d.
C247717

Remove the 2 nuts and bracket (with 4-way).


e.

Pull out the master cylinder from the brake booster.


f.

Remove the O-ring from the master cylinder.


Hide 3.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ ABS)

C247714

a.

for Manual Transmission:

Disconnect the clutch reservoir tube from the master cylinder.


b.

Disconnect the brake fluid level warning switch connector.


c.

Using a union nut wrench, disconnect the 5 brake lines from the master cylinder and 3-way.


d.
C247715

Remove the 2 nuts and bracket (with 3-way).


e.

Pull out the master cylinder from the brake booster.


f.

Remove the O-ring from the master cylinder.