Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 4WD and Pre-Runner)
RM1840EF _54 Brake _009625 BRAKE (FRONT) _0052625 FRONT BRAKE(for 4WD and Pre-Runner) A

BRAKE (FRONT)  FRONT BRAKE(for 4WD and Pre-Runner)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE CYLINDER BOOT

a.
C111378
1.479,0.148 1.632,0.289 0.152,0.14 10 *1 1.855,0.697 1.716,0.225 1.716,0.225 1.656,0.225 false
*1 Protective Tape


Using a screwdriver, remove the 4 set rings and 4 cylinder boots from the disc brake cylinder.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Be careful not to damage the brake piston and disc brake cylinder.



Hide 2.REMOVE FRONT DISC BRAKE PISTON

a.
C111364
1.229,0.188 1.406,0.354 0.177,0.167 10 false *a 2.938,0.885 3.104,1.031 0.167,0.146 10 false *b 3.094,1.375 3.25,1.531 0.156,0.156 10 false *c
*a 170 mm (6.70 in.)
*b 50 mm (1.97 in.)
*c 25 mm (0.99 in.)


Prepare a wooden plate to hold the pistons.


b.
C111379

Place the wooden plate between the pistons and insert a pad on one side.


c.

Use compressed air to remove the 4 pistons from the cylinder.

CAUTION:

Do not place your finger in front of the piston when using compressed air.


NOTICE:

Be careful not to spatter the brake fluid.



Hide 3.REMOVE PISTON SEAL

a.
C111380
1.729,0.646 1.396,0.208 1.396,0.208 1.052,0.208 true 1.802,0.625 1.802,0.667 false 1.75,0.635 1.75,0.688 false 1.698,0.646 1.698,0.708 false 1.656,0.688 1.656,0.729 false 1.604,0.708 1.604,0.75 false 1.552,0.719 1.552,0.771 false 0.875,0.125 1.021,0.26 0.146,0.135 10 false *1
*1 Protective Tape


Using a screwdriver, remove the 4 piston seals from the cylinder.

NOTICE:

Be careful not to damage the inner cylinder and cylinder groove.



Hide 4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 5.REMOVE FRONT DISC BRAKE BLEEDER PLUG