Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 4WD and Pre-Runner)
RM1840EF _54 Brake _009625 BRAKE (FRONT) _0052625 FRONT BRAKE(for 4WD and Pre-Runner) A

BRAKE (FRONT)  FRONT BRAKE(for 4WD and Pre-Runner)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG

a.

Temporarily install the bleeder plug to the cylinder.

HINT:

The bleeder plug will be tightened to a torque specification in the Bleed Brake Line procedures.



b.

Install the cap to the bleeder plug.


Hide 2.INSTALL PISTON SEAL

a.

Apply a light coat of lithium soap base glycol grease to 4 new piston seals.


b.

Install the 4 piston seals to the disc brake cylinder.


Hide 3.INSTALL FRONT DISC BRAKE PISTON

a.
C236942
0.687,1.673 0.838,1.816 0.151,0.143 10 *1
*1 Lithium soap base glycol grease


Apply lithium soap base glycol grease to the 4 pistons and 4 new cylinder boots.


b.

Install the 4 boots to the pistons.


c.

Install the 4 pistons (with the boots) to the cylinder.

NOTICE:

Do not forcibly install the pistons to the cylinder.



Hide 4.INSTALL CYLINDER BOOT

C236943

a.

Install the 4 boots to the cylinder.


b.

Using a screwdriver, install the 4 set rings.

NOTICE:

Be careful not to damage the boot.