Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 2WD) › from 2012.10
RM1840EF _54 Brake _009625 BRAKE (FRONT) _0052627 FRONT BRAKE(for 2WD) A

BRAKE (FRONT)  FRONT BRAKE(for 2WD)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 3.DISCONNECT FRONT FLEXIBLE HOSE

a.
C111360

Remove the union bolt and gasket.


b.

Disconnect the flexible hose from the disc brake cylinder.


Hide 4.REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

a.
C111361

Remove the 2 bolts and disc brake cylinder assembly.


Hide 5.REMOVE NO. 1 CYLINDER SLIDE BUSH

a.
C238099

Remove the No. 1 cylinder slide bush from the disc brake cylinder assembly.


Hide 6.REMOVE NO. 2 CYLINDER SLIDE BUSH

a.

Remove the No. 2 cylinder slide bush from the disc brake cylinder assembly.


Hide 7.REMOVE FRONT DISC BRAKE BUSH DUST BOOT

a.
C238098

Remove the 4 boots from the disc brake cylinder assembly.


Hide 8.REMOVE NO. 1 COLLAR

a.

Remove the No. 1 collar from the disc brake cylinder assembly.


Hide 9.REMOVE NO. 2 COLLAR

a.

Remove the No. 2 collar from the disc brake cylinder assembly.


Hide 10.REMOVE FRONT DISC BRAKE PAD

a.

Remove the 2 front disc brake pads from the disc brake cylinder.


Hide 11.REMOVE FRONT ANTI-SQUEAL SHIM KIT

a.

Remove the No. 1 anti-squeal shim and No. 2 anti-squeal shim from each pad.


Hide 12.REMOVE PAD WEAR INDICATOR PLATE

a.

Remove the pad wear indicator plates from the disc brake pad.


Hide 13.REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Remove the 4 pad support plates from the brake cylinder mounting.


Hide 14.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH

a.

Remove the 2 bolts and cylinder mounting.


Hide 15.REMOVE FRONT DISC

a.
C111369
0.599,0.27 0.748,0.41 0.149,0.14 10 *1 1.674,1.112 0.902,0.346 0.902,0.346 0.776,0.346 false 1.677,1.236 0.903,0.346 false
*1 Matchmark


Put matchmarks on the disc and axle hub.


b.

Remove the disc.