Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 2WD) › from 2012.10
RM1840EF _54 Brake _009625 BRAKE (FRONT) _0052627 FRONT BRAKE(for 2WD) A

BRAKE (FRONT)  FRONT BRAKE(for 2WD)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG

a.

Temporarily install the bleeder plug to the cylinder.

HINT:

The bleeder plug will be tightened to the torque specification in the Bleed Brake Line procedure.



Hide 2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.
C191865
0.795,2.915 0.948,3.064 0.153,0.149 10 *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.


b.

Install the piston seal to the disc brake cylinder assembly.

NOTICE:

Make sure the piston seal is securely installed to the groove of the disc brake cylinder assembly.



Hide 4.INSTALL FRONT DISC BRAKE PISTON

a.
C238097
0.708,2.885 0.875,3.021 0.167,0.135 10 false *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the inner and outer circumference of a new cylinder boot, and the entire circumference of the top and bottom of the outer edge as shown in the illustration.


b.

Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the front disc brake piston where it contacts the cylinder boot and front disc brake cylinder.


c.

Install the cylinder boot to the front disc brake piston.


d.

Install the front disc brake piston to the front disc brake cylinder.

NOTICE:

Do not forcibly install the disc brake piston to the disc brake cylinder.



Hide 5.INSTALL CYLINDER BOOT

a.
C111372
2.813,0.938 2.813,0.156 2.813,0.156 2.146,0.156 false 2.917,1.104 2.917,1.615 false 2.833,1.688 2.99,1.833 0.156,0.146 10 false *2 1.927,0.073 2.083,0.219 0.156,0.146 10 false *1
*1 Set Ring
*2 Cylinder Boot


Install the cylinder boot to the disc brake cylinder.

NOTICE:

Securely install the cylinder boot to the groove of the disc brake cylinder.



b.

Using a screwdriver, install a new set ring.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the cylinder boot.