Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.CHECK BRAKE SHOE LINING THICKNESS
Remove the shoe inspection hole plug, and check the shoe lining thickness through the hole.
1.0 mm (0.0394 in.)
If the thickness is less than the minimum, replace the shoe.
2.REMOVE REAR WHEEL
3.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
4.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
Release the parking brake lever, and remove the drum and gasket.
If the drum cannot be removed easily, perform the following procedures.
| *1 | Automatic Adjust Lever |
| *2 | Brake Shoe Adjuster |
Remove the shoe adjusting hole plug and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, compress the shoe adjuster by turning the adjusting wheel.