Home › Brake › BRAKE (REAR) › REAR BRAKE(for 2WD) › from 2012.10
RM1840EF _54 Brake _009626 BRAKE (REAR) _0052632 REAR BRAKE(for 2WD) A

BRAKE (REAR)  REAR BRAKE(for 2WD)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.CHECK BRAKE SHOE LINING THICKNESS

a.
C111393

Remove the shoe inspection hole plug, and check the shoe lining thickness through the hole.

Minimum thickness:

1.0 mm (0.0394 in.)


If the thickness is less than the minimum, replace the shoe.


Hide 2.REMOVE REAR WHEEL

Hide 3.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 4.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

a.

Release the parking brake lever, and remove the rear brake drum.

HINT:

If the rear brake drum cannot be removed easily, perform the following procedures.



b.
C111394
1.344,0.844 1.344,0.135 1.344,0.135 1.813,0.135 true 1.583,0.906 1.583,0.531 1.583,0.531 2.219,0.531 true 1.854,0.052 2.094,0.219 0.24,0.167 10 false *1 2.24,0.448 2.479,0.604 0.24,0.156 10 false *2
*1 Automatic Adjust Lever
*2 Brake Shoe Adjuster


Remove the shoe adjusting hole plug and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.


c.

Using another screwdriver, compress the brake shoe adjuster by turning the adjusting wheel.