When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
1.SECURE VANE PUMP ASSEMBLY
Using SST, secure the vane pump between aluminum plates in a vise as shown in the illustration.
2.REMOVE POWER STEERING SUCTION PORT UNION
Remove the bolt and suction port union.
Remove the O-ring from the suction port union.
3.REMOVE FLOW CONTROL VALVE
Using a 27 mm socket wrench, remove the pressure port union from the front housing.
Using a screwdriver, remove the O-ring from the pressure port union.
Remove the flow control valve from the front housing.
Remove the compression spring from the front housing.
4.REMOVE REAR VANE PUMP HOUSING
Remove the 4 bolts and rear housing.
Remove the O-ring from the rear housing.
5.REMOVE VANE PUMP ROTOR
Remove the 10 vane pump plates from the vane pump rotor.
Be careful not to drop the vane pump plates.
Remove the vane pump rotor.
6.REMOVE VANE PUMP CAM RING
7.REMOVE FRONT VANE PUMP SIDE PLATE
Remove the side plate from the front housing.
Remove the O-ring from the side plate.
Remove the O-ring from the front housing.