Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for KD Series Engine)
RM1840EF _55 Steering _009628 POWER ASSIST SYSTEMS _0052639 VANE PUMP(for KD Series Engine) A

POWER ASSIST SYSTEMS  VANE PUMP(for KD Series Engine)  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSTALL FRONT VANE PUMP SIDE PLATE

a.
G020532

Coat a new O-ring with power steering fluid.


b.

Install the O-ring to the front housing.


c.
C065368

Coat a new O-ring with power steering fluid.


d.

Install the O-ring to the front side plate.


e.
G020534

Install the side plate to the front housing while aligning the semicircle-shaped cuts of both parts.

NOTICE:

Be sure to install the plate in the correct position and with the correct orientation.



Hide 2.INSTALL VANE PUMP CAM RING

a.
G020533
0.969,0.25 0.813,0.125 0.813,0.125 0.646,0.125 true 0.469,0.052 0.979,0.479 0.51,0.427 10 false *1
*1 Engraved Mark


With the engraved mark facing upward, install the cam ring to the housing while aligning the semicircle-shaped cuts of both parts.

NOTICE:

Be sure to install the ring in the correct position and with the correct orientation.



Hide 3.INSTALL VANE PUMP ROTOR

a.
F012764

Install the vane pump rotor.


b.

Install the 10 vane pump plates with the round ends facing outward.


Hide 4.INSTALL REAR VANE PUMP HOUSING

a.

Coat a new O-ring with power steering fluid and install it to the rear housing.


b.
G020530

Align the straight pin of the rear housing with the hole created by the semicircle-shaped cuts of the cam ring, front side plate and front housing.

NOTICE:

Make sure that the O-ring is not out of position before installing the rear vane pump housing.



c.
G021499

Install the rear housing with the 4 bolts.

Torque:
22 N*m (224 kgf*cm, 16 ft.*lbf)


Hide 5.INSPECT ROTATING TORQUE

a.
F014160
2.979,0.927 3.219,1.125 0.24,0.198 10 false *1
*1 Bolt


Check that the pump rotates smoothly without abnormal noise.


b.

Temporarily install a bolt to the vane pump shaft.


c.

Using a 10 mm socket wrench, check the power steering vane pump rotating torque.

Standard rotating torque:

0.27 N*m (2 kgf*cm, 2 in.*lbf) or less



Hide 6.INSTALL FLOW CONTROL VALVE

a.
G021497

Install the spring.


b.

Install the flow control valve so that it faces the correct direction.


c.

Coat a new O-ring with power steering fluid and install it to the pressure port union.


d.

Install the pressure port union.

Torque:
69 N*m (704 kgf*cm, 51 ft.*lbf)


Hide 7.INSTALL POWER STEERING SUCTION PORT UNION

a.

Coat a new O-ring with power steering fluid and install it to the suction port union.


b.

Install the suction port union with the bolt.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)