1.DRAIN POWER STEERING FLUID
2.REMOVE FAN AND GENERATOR V BELT
3.DISCONNECT RETURN HOSE
Detach the clip and disconnect the hose.
4.DISCONNECT PRESSURE FEED TUBE ASSEMBLY
Remove the union bolt and disconnect the pressure feed tube from the vane pump.
Remove the gasket from the pressure feed tube.
5.REMOVE VANE PUMP ASSEMBLY
Disconnect the connector from the power steering oil pressure switch.
Remove the 2 bolts and vane pump.
6.REMOVE VANE PUMP OIL RESERVOIR CAP SUB-ASSEMBLY
7.REMOVE VANE PUMP OIL RESERVOIR SUB-ASSEMBLY
Remove the 3 bolts and oil reservoir from the front vane pump housing.
Using a screwdriver, remove the O-ring from the oil reservoir.