Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for TR Series Engine)
RM1840EF _55 Steering _009628 POWER ASSIST SYSTEMS _0052640 VANE PUMP(for TR Series Engine) A

POWER ASSIST SYSTEMS  VANE PUMP(for TR Series Engine)  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.SECURE VANE PUMP ASSEMBLY

a.
G036582
2.25,1.406 1.854,1.406 false 2.333,1.323 2.656,1.51 0.323,0.188 10 false SST

Using SST, secure the vane pump between aluminum plates in a vise, as shown in the illustration.

SST
09630-00014  (09631-00132)


Hide 2.REMOVE FLOW CONTROL VALVE

a.
C084485

Using a 27 mm socket wrench, remove the pressure port union from the front housing.


b.

Using a screwdriver, remove the O-ring from the pressure port union.


c.

Remove the flow control valve from the front housing.


d.

Remove the compression spring from the front housing.


Hide 3.REMOVE POWER STEERING OIL PRESSURE SWITCH

a.

Remove the oil pressure switch from the front housing.


b.

Remove the O-ring from the oil pressure switch.


Hide 4.REMOVE REAR HOUSING

a.
C084483

Remove the 4 bolts and rear housing from the front housing.


b.

Remove the O-ring from the rear housing.


Hide 5.REMOVE SHAFT WITH PULLEY

a.
C057767

Using a screwdriver, remove the shaft snap ring from the shaft with pulley.


b.

Remove the shaft with pulley from the rear housing.


Hide 6.REMOVE VANE PUMP ROTOR

a.

Remove the 10 vane pump plates from the vane pump rotor.

NOTICE:

Be careful not to drop the vane pump plates.



b.

Remove the vane pump rotor from the front housing.


Hide 7.REMOVE VANE PUMP CAM RING

Hide 8.REMOVE FRONT VANE PUMP SIDE PLATE

a.

Remove the front vane pump side plate from the front housing.


b.
C065368

Remove the No. 1 O-ring from the side plate.


c.
C065369

Remove the No. 2 O-ring from the front housing.


Hide 9.REMOVE VANE PUMP HOUSING OIL SEAL

a.
G034363

Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.