When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
1.INSTALL VANE PUMP HOUSING OIL SEAL
Using SST and a press, press in a new oil seal.
Make sure to install the oil seal so that it face the correct direction.
Be careful not to damage the oil seal.
2.INSTALL SHAFT WITH PULLEY
Coat the shaft with power steering fluid.
| *1 | Protective Tape |
Tape the serrated part of the shaft.
Be careful not to damage the oil seal.
Install the shaft with pulley to the front housing.
3.INSTALL FRONT VANE PUMP SIDE PLATE
Coat a new No. 2 O-ring with power steering fluid.
Install the No. 2 O-ring to the front housing.
Coat a new No. 1 O-ring with power steering fluid.
Install the No. 1 O-ring to the front side plate.
Install the front side plate to the front housing while aligning the semicircle-shaped cuts of both parts.
Be sure to install the plate in the correct position and with the correct orientation.
4.INSTALL VANE PUMP CAM RING
| *1 | Inscribed Mark |
With the inscribed mark facing upward, install the vane pump cam ring to the front housing while aligning the semicircle-shaped cuts of both parts.
Be sure to install the plate in the correct position and with the correct orientation.
5.INSTALL VANE PUMP ROTOR
Install the vane pump rotor to the front housing.
The top and bottom of the vane pump rotor are symmetrical.
| *a | Outward |
| *b | Inward |
Coat the 10 vane pump plates with power steering fluid.
Install the 10 vane pump plates.
Make sure that the round ends of the vane pump plates are facing outward.
6.INSTALL VANE PUMP SHAFT SNAP RING
Using a screwdriver and snap ring expander, install a new snap ring to the shaft with pulley.
7.INSTALL REAR HOUSING
Coat a new O-ring with power steering fluid and install it to the rear housing.
Align the straight pin of the rear housing with the hole created by the semicircle-shaped cuts of the cam ring, front side plate and front housing. Then install the rear housing with the 4 bolts.
Make sure that the O-ring is not out of position before installing the rear housing.
8.INSPECT ROTATING TORQUE
Check that the pump rotates smoothly without abnormal noise.
Temporarily install the service bolt.
| Item | Specified Condition |
|---|---|
| Thread Diameter | 10 mm (0.394 in.) |
| Thread Pitch | 1.25 mm (0.0492 in.) |
| Bolt Length | 50 mm (1.97 in.) |
Using a torque wrench, check the pump rotating torque.
0.27 N*m (3 kgf*cm, 2 in.*lbf) or less
If the rotating torque is not as specified, check the installation of the housing oil seal.
9.INSTALL POWER STEERING OIL PRESSURE SWITCH
Coat a new O-ring with power steering fluid and install it to the oil pressure switch.
Install the oil pressure switch to the vane pump.
10.INSTALL FLOW CONTROL VALVE
Coat the compression spring and flow control valve with power steering fluid.
Install the compression spring.
Install the flow control valve so that it faces the correct direction.
Coat a new O-ring with power steering fluid and install it to the pressure port union.
Install the pressure port union.
11.INSTALL VANE PUMP OIL RESERVOIR SUB-ASSEMBLY
Coat a new O-ring with power steering fluid, and install it to the vane pump oil reservoir.
Install the vane pump oil reservoir to the vane pump with the 3 bolts.
12.INSTALL VANE PUMP OIL RESERVOIR CAP SUB-ASSEMBLY