Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE STEERING PAD ASSEMBLY (for 3 Spoke)
Remove the screw.
Detach the 3 pins and remove the steering pad.
Disconnect the horn wire.
4.REMOVE STEERING PAD (for 4 Spoke)
5.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Multi-information Display)
6.REMOVE STEERING PAD SWITCH LH (w/o Multi-information Display)
7.REMOVE NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
| *1 | Pin |
Remove the screw.
Detach the 2 pins and remove the steering wheel ornament.
8.REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
| *1 | Pin |
Remove the screw.
Detach the 2 pins and remove the steering wheel ornament.
9.REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)
10.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel assembly set nut.
| *A | for 3 Spoke |
| *B | for 4 Spoke |
| *1 | Matchmark |
| *a | Turn |
| *b | Hold |
Put matchmarks on the steering wheel assembly and steering main shaft.
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.