1.INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Multi-information Display)
Attach the 4 pins to install the steering pad switch.
Install the 2 screws.
Connect the connectors and attach the 2 clamps.
2.INSTALL STEERING PAD SWITCH LH (w/o Multi-information Display)
Refer to the step "INSTALL STEERING PAD SWITCH ASSEMBLY".
3.INSTALL STEERING PAD ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
5.CHECK SRS WARNING LIGHT