Home › Audio / Visual / Telematics › AUDIO / VIDEO › AMPLIFIER ANTENNA › 2011.10–2012.01
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052653 AMPLIFIER ANTENNA A

AUDIO / VIDEO  AMPLIFIER ANTENNA  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE ANTENNA WITH HOLDER ASSEMBLY (for Double Cab)

a.

Disconnect the connector.


b.

Detach the cable from 3 clamps.


c.

Remove the nut.

E225602


d.
B208915

Detach the 2 claws and remove the with holder antenna assembly.