Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) › 2011.10–2012.01
RM1840EF _56 Audio / Visual / Telematics _009631 AUDIO / VIDEO _0052656 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  CB-10  System Microcomputer Malfunction  CB-11  Media Interface Microcomputer Malfunction  CB-12  CD-LSI Malfunction  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
CB-10 System Microcomputer Malfunction A system microcomputer malfunction.
·

"iPod" or USB device

·

Radio receiver assembly


CB-11 Media Interface Microcomputer Malfunction A media interface microcomputer malfunction.
·

"iPod" or USB device

·

Radio receiver assembly


CB-12 CD-LSI Malfunction A CD-LSI (large scale integration) malfunction.
·

"iPod" or USB device

·

Radio receiver assembly



CAUTION / NOTICE / HINT

NOTICE:

The data stored on the USB device or "iPod" may be changed or lost due to malfunctions, repairs, system errors, etc. Therefore, when repairs are to be performed, explain this to the customer and obtain their consent prior to performing repairs.


HINT:

After the inspection is completed, clear the DTCs.


PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the stereo jack adapter.


b.

Turn the ignition switch off.

HINT:

When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.



c.

Turn the ignition switch to ACC.


d.

Connect a known good USB device or "iPod" to the stereo jack adapter.


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Check for DTCs and check if the same DTC occurs again.

HINT:

If DTCs are output frequently, replace the radio receiver assembly.


OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END (USB DEVICE OR "iPod" WAS DEFECTIVE)

NG

REPLACE RADIO RECEIVER ASSEMBLY