Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › 2012.04–2012.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052659 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 4.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

a.
E237851

Remove the 4 screws.


b.

Disconnect all the connectors and remove the navigation receiver assembly with bracket.


Hide 5.REMOVE NO. 1 RADIO BRACKET

a.
E237852

Remove the 3 screws and No. 1 radio bracket from the navigation receiver.


Hide 6.REMOVE NO. 2 RADIO BRACKET

a.
E237853

Remove the 3 screws and No. 2 radio bracket from the navigation receiver.