Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ANTENNA › 2012.04–2012.10
RM1840EF _56 Audio / Visual / Telematics _009632 NAVIGATION / MULTI INFO DISPLAY _0052660 NAVIGATION ANTENNA A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION ANTENNA  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.REMOVE NAVIGATION ANTENNA ASSEMBLY

a.
E237855

Detach the clamp and disconnect the connector.


b.

Remove the 2 screws and navigation antenna assembly.


Hide 5.REMOVE NO. 1 NAVIGATION ANTENNA CORD SUB-ASSEMBLY

a.
E237856

Disconnect the connector.


b.

Detach the clamp and remove the No. 1 navigation antenna cord sub-assembly.