This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the telephone microphone assembly.
| *a | Component without harness connected
(Navigation Receiver Assembly) |
Disconnect the G152 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G152-18 (SGND) - Body ground | Always | Below 1 Ω |
| G152-19 (MIN-) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G152-4 (MACC) - Body ground | Ignition switch ACC | 4 to 6 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G152 navigation receiver assembly connector.
Disconnect the N2 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G152-4 (MACC) - N2-4 (MACC) | Always | Below 1 Ω |
| G152-5 (MIN+) - N2-3 (MCO+) | Always | Below 1 Ω |
| G152-19 (MIN-) - N2-2 (MCO-) | Always | Below 1 Ω |
| G152-18 (SNS2) - Body ground | Always | Below 1 Ω |
| G152-4 (MACC) - Body ground | Always | 10 kΩ or higher |
| G152-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| G152-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG