Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type) › 2012.01–2013.10
RM1840EF _56 Audio / Visual / Telematics _009633 PARK ASSIST / MONITORING _0052664 REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type) U

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type)  TERMINALS OF ECU  


CHECK NAVIGATION RECEIVER ASSEMBLY


E234522
1.126,1.96 1.523,2.198 0.397,0.238 1.154,2.006 1.511,2.188 0.357,0.182 10 G105 1.898,1.96 2.295,2.198 0.397,0.238 1.925,2.006 2.283,2.188 0.357,0.182 10 G104 3.221,1.08 3.618,1.319 0.397,0.238 3.248,1.127 3.605,1.308 0.357,0.182 10 G153 4.327,1.08 4.724,1.319 0.397,0.238 4.354,1.127 4.712,1.308 0.357,0.182 10 G152 4.279,2.153 4.676,2.391 0.397,0.238 4.403,2.199 4.567,2.381 0.164,0.182 10 z7 6.043,1.765 6.44,2.004 0.397,0.238 6.144,1.812 6.354,1.993 0.211,0.182 10 RA

a.

Disconnect the G105 navigation receiver assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specification
G105-3 (ACC) - G105-7 (GND) GR - BR Accessory (ON) Ignition switch off Below 1 V
Ignition switch ACC 11 to 14 V
G105-4 (B) - G105-7 (GND) L-Y - BR Battery Always 11 to 14 V
G105-7 (GND) - Body ground BR - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the G105 navigation receiver assembly connector.


d.

Measure the voltage and waveform according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specification
G152-2 (REV) - G105-7 (GND) R-Y - BR Reverse signal Ignition switch ON, shift lever in R 7.5 to 14 V
Ignition switch ON, shift lever not in R Below 1 V
G153-7 (CA+) - G153-15 (CGND) B - Shielded Power source Ignition switch ON, shift lever in R 5.5 to 7.05 V
G153-8 (V+) - G153-16 (V-) W - R Display signal Ignition switch ON, shift lever in R Pulse generation (See waveform 1)
Ignition switch ON, shift lever in R, screen blacked out by covering camera lens Pulse generation (See waveform 2)
G153-15 (CGND) - Body ground Shielded - Body ground Shielding Always Below 1 V

If the result is not as specified, the navigation receiver assembly may have a malfunction.


e.

Using an oscilloscope, check the waveform.

E272452
1.01,2.333 1.188,2.333 1.188,2.333 1.302,1.865 false 1.781,2.333 1.625,2.333 1.625,2.333 1.417,1.771 false 5.063,2.292 4.906,2.292 4.906,2.292 4.667,1.625 false 4.25,2.292 4.427,2.292 4.427,2.292 4.542,1.698 false 0.563,1.302 1.021,1.5 0.458,0.198 10 false GND 3.771,1.281 4.229,1.479 0.458,0.198 10 false GND 0.458,0.313 0.917,0.51 0.458,0.198 10 false *a 3.698,0.26 4.156,0.458 0.458,0.198 10 false *b 0.844,2.24 1.302,2.438 0.458,0.198 10 false *c 1.833,2.25 2.292,2.448 0.458,0.198 10 false *d 4.115,2.198 4.573,2.396 0.458,0.198 10 false *c 5.135,2.229 5.594,2.427 0.458,0.198 10 false *d
*a Waveform 1 *b Waveform 2
*c Synchronized Signal *d Video Waveform


i.

Waveform 1

Measurement Condition
Item Content
Terminal No. (Symbol) G153-8 (V+) - G153-16 (V-)
Tool Setting 0.2 V/DIV., 50 μs/DIV.
Condition Ignition switch ON, shift lever in R

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.



ii.

Waveform 2

Measurement Condition
Item Content
Terminal No. (Symbol) G153-8 (V+) - G153-16 (V-)
Tool Setting 0.2 V/DIV., 50 μs/DIV.
Condition Ignition switch ON, shift lever in R, screen blacked out by covering camera lens

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.