Home › Power Source / Network › 1KD-FTV BATTERY / CHARGING › GENERATOR(for DENSO Made)
RM1840EF _57 Power Source / Network _009635 1KD-FTV BATTERY / CHARGING _0052669 GENERATOR(for DENSO Made) G

1KD-FTV BATTERY / CHARGING  GENERATOR(for DENSO Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT GENERATOR WITH CLUTCH PULLEY

a.
A226388
1.094,0.771 1.219,0.688 false
V100135

Free
V100136

Lock


Hold the center of the generator with clutch pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

If the result is not as specified, replace the generator with clutch pulley.


Hide 2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A113754
0.688,0.677 0.865,0.844 0.177,0.167 10 false *1
*1 Length


Using a vernier caliper, measure the brush length.

Standard length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum length:

4.5 mm (0.177 in.)


If the length is less than the minimum, replace the brush holder assembly.


Hide 3.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A079306

Inspect that the bearing is not rough or worn.

If necessary, replace the generator rotor assembly.


b.
B012264
0.354,1.146 0.479,0.146 0.479,0.146 0.469,1.052 true 0.479,0.156 1.531,0.156 true 1.583,0.063 1.813,0.229 0.229,0.167 10 false *1
*1 Slip Ring


Check the rotor for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.85 to 2.25 Ω


If the result is not as specified, replace the generator rotor assembly.



c.
B012265
1.625,0.458 1.542,0.458 1.542,0.458 1.313,0.76 true 0.448,1.229 0.823,1.594 0.823,1.594 1.052,1.594 false 1.698,0.323 1.854,0.49 0.156,0.167 10 false *1 1.104,1.51 1.281,1.667 0.177,0.156 10 false *2
*1 Rotor Core
*2 Slip Ring


Check if the rotor is grounded.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Rotor - Slip ring Always 10 kΩ or higher


If the result is not as specified, replace the generator rotor assembly.



d.
B012266

Using a vernier caliper, measure each slip ring diameter.

Standard diameter:

14.2 to 14.4 mm (0.559 to 0.567 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If either diameter is less than the minimum, replace the rotor.